| View previous topic :: View next topic |
| Author |
Message |
Chicopromo
spectator
Joined: 07 Mar 2006
Posts: 3
|
 Posted: Tue Mar 07, 2006 8:50 pm Post subject: hight speed adjust |
 |
|
Hi,
2 question:
1- i cant got full speed trottle on 1/2 to full trottle course the engine revolutions drop dramatiq and engine cut out.
i open low speed 45 minutes and it's better but not perfect. i dont know if i need turn agan 10 minutes or turn high speed neddle 10 minutes.
?
2- pressure inlet is connected to inlet motor (crankshaft) ???? |
|
| Back to top |
|
 |
preivers
Site Admin
Joined: 23 Oct 2005
Posts: 81
Location: Arcen
|
| Posted: Sat Mar 11, 2006 10:37 pm Post subject: |
|
|
there is a difference between engines.
26 and 35cc have a nipple in the crankcase, that is connected to the carb (carb intake manifold).
43 and 58 cc have a connection in the rear cover that is connected to the carb (carb cast cover nipple)
to cure your condition: since the engine runs at idle, open up the high speed needle, until it will accept more throttle. See the walbro tuning section on this forum.
_________________
PRME - Pe Reivers Model Engines
Dealer for MVVS, Mejzlik, MTW
http://www.mvvs.nl
http://www.prme.nl
http://www.mvvs-nl.com |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB NoBots © 2001, 2002 phpBB Group
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
